DCH Firearms

10/10/2015

10/10/2015

Me shooting the Sig Sauer P226 for our "Set Your Sights On A Cure" challenge. At 10 yards I shot a $49.40 donation amount. I should have slowed down but its soooooo hard.

10/10/2015

10/10/2015

Tamra shooting the Beretta Cougar 40S&W for DCH Fi****ms "Set Your Sights ON A Cure" challenge. Yes, she loads, runs the slide, shoots and clears malfunctions but I can't get her to CLEAN them!

10/10/2015

07/12/2015

Now you can see the difference that is made after removing the two blocks at the end of the stock. The barrel still contacted the stock just a bit, so knowing we are going to change the stock soon we added some shims under the front of the action between the recoil lug and the front action screw. We do NOT recommend this as a permeant fix. Replace your stock or have your gunsmith (us) free float your barrel and bed the action. Again the target distance was 100 yards and Hornady ammunition.

07/12/2015

This shows the importance of having a free floated barrel. The factory Re*****on stock has two square molded in blocks that touch the under side of the barrel that put pressure and change the harmonics of the barrel. At only 100 yards it is not able to produce a consistent group.

07/07/2015

G***k 41 gen4 .45ACP, with grip reduction and contour enhancement.

07/07/2015

G***k 41 gen4 .45ACP, untouched.

07/07/2015

G***K? There's no denying the ruggedness and dependability of a G***k. There is however some difficulties for a lot of shooters to like the grip. 1. The grip angle and bulged heel tend to make it point high. 2. The finger grooves don't seem to line up right with you grip. 3. Shoot for any length of time and you get that "G***k knuckle" on your middle finger from the trigger guard. 4. The upper frame area above the trigger rubs and pushes your finger down as you manipulate the trigger. But hey, its a G***k, they just work no matter what you put them through so you'll deal with a few ergonomic shortcomings right? NO, you don't have to! We can correct all of the ergonomic problems on your G***k, then you won't just rely on your G***k you will LOVE it.

07/07/2015

I know its been a while since we have posted anything but yes we are still here and working on projects. We have received a chassis system for the 7mm-08. We would like to hear from you if you want to see us try to get the maximum accuracy while using the factory stock and truing the action or installing the factory untouched action into the chassis system. Tell us what you would like to see.

06/13/2015

Director of the SIG SAUER Academy in New Hampshire, Adam Painchaud shares a defensive pistol tip to ensure a safe holster draw while seated in your vehicle--...