Osprey Crafts

05/19/2026

Here are are couple fish boards from Osprey Crafts in action in Canada. Nice work, gentlemen.

https://www.instagram.com/reel/DXAlBwaDC3t/?igsh=MXNoNzRhaXJyZWJvbA==

03/11/2026

We had a little taste of spring in Maine today. It's a good time to order that anchor system for your Scott/Maine Freighter or your Old Town canoe. They'll go quickly as we approach ice-out!

11/03/2024

In addition to logos, I can now also offer a laser-engraved ruler on my fish boards. I've been testing these in the field and I really like this option. When I started making boards, I was using aluminum rulers. They nearly doubled in price over the past 4 years and the numbers often chip or peel off over time. I recently switched to vinyl rulers from Oregon Rule Co. and they are great. No chipping or fading, although sometimes the epoxy covering will lift the ruler at the edges. However, with a laser-engraved ruler there is no risk of chipping or loosing the edge. The laser-engraved rulers are accurate, permanent, and easy to read. I think these rulers/boards will last longer than me 😃. This option is available at no extra charge.

11/03/2024

I’ve been making fish boards for quite a few years. During that time, I’ve had a few requests for personalization or logos. I never really had the tools or skills to pull it off. But I recently added a laser to my workshop. I’m at the point where I feel I can offer these on all my orders, whether it's a fish board or canoe accessory. Below are a few examples. So, if you are interested in adding some bling to your order, just drop me an email at [email protected] and we’ll see what we can do.

06/29/2024

Hex hatch is on, so it's vacation week. We'll be back on the 8th.

01/29/2023

New vid on installing a fish finder in a Scott Canoe/Maine Freighter.

This is the number one question I get from owners of Scott Canoes and Maine Freighters. Installing an in-hull transducer is the best way to go. #...

06/16/2022

A lot of owners want to put a trolling motor on the bow. It can be done and here are a couple options. The most important component is a trolling motor with a long shaft. Your 36" shaft from your Old Town Canoe isn't going to cut it. You need a 52" or better or you'll be banging on the side of your Scott Canoe/Maine Freighter. I recently modified one of my transom trolling motor mounts (shortened it and added a bolt hole) so it would mount on the bow and with my anchor arm. I also mocked up a prototype for a typical bow mount trolling motor (photos below). I used AdvanTech OSB to form two trapezoids that are clamped over the gunwales using 3/8 carriage bolts and k***s. I plan to coat this with West Systems Epoxy and then paint with a marine grade paint (Pettit). I've included the dimensions in one of the photos, if anyone is interested in building one.

06/12/2022

This week, I'm going to address the two most asked questions I get about Scott canoes/ Maine Frieghters.

1. Can I put a trolling motor on the bow?

2. What's the best way to mount a transducer for my fish finder?

04/03/2022

Here in northern Maine we still have snow and ice, but spring is near. Are you ready?

07/03/2021

It's that time of the year again. I will be away from the shop until July 12th chasing the Hex hatch and feasting on whoopie pies...at the same time. Tight Lines!

05/06/2021

New fish measurement boards are now back in stock. Shoot me an email for your custom board needs.