MAD Custom Arms

11/08/2025

I have a Wi******er 20ga Model 12 come in with a separated action tube assembly. After noting the tube appears to be either dimpled or spot welded to hold it together which of course didn't hold. So I welded the action bar assembly to the tube. ******er

10/31/2025

Just doing hot guy s**t.

10/23/2024

10/10/2024

Surprisingly, while , the Benelli/Stoeger guys were there promoting Stoegers new line of handguns. Of course, they didn't know that I had attended this event for years, and when they saw my table, a few of them wanted to shoot my guns. Here's Chris from Stoeger sporting my . Nice to see you guys outside of the weekly grind. #45

10/10/2024

Hi MAD Custom fans, my lovely wife and I went down to Georgia for IV8888 Annual Range Day! Her first time and it was a pleasure to see the smile on her face after shooting our machine guns. Love you baby. You're the best! #545×39

07/10/2022

Been a while since I posted but here is the new location of MAD Custom Arms. Still a lot to do before reopening. There is so much room for activities.

05/10/2022

Doing a little Cerakoting and slide machining for RMR install. Cerakote rose gold and coyote tan.

05/06/2022

Had an old Re*****on model 12 come in for refinishing. These are the types of guns that make me think about setting my bluing tanks back up. It's too bad I dont get enough to justify the cost of bluing. So it gets the next closest look, midnight blue cerakote.

The cool item on this rifle is the vintage marbles peep sight. This sight I have to spray it carefully to allow for reassembly without binding and of course quick adjustments.

04/27/2022

PUBLIC SERVICE ANNOUNCEMENT"
When loading your fi****ms please make sure the loading area is clear. The customer said his buddy was hand cycling the slide and in the process of the cartridges ejecting, this particular cartridge managed to flip when coming out and the operator didn't see it still in the gun and drove the slide forward slamming the cartridge rearward into the chamber thus sticking it beyond any normal finger pressure to remove.

04/19/2022

Had a S&W pro series M&P 9 come in for a little upgrade. Machined out slide for Holosun 507CX2 and moved the rear sight in front of the optic. Due to size limitation on this slide I machined a dovetail to use a Sig Sauer suppressor height rear sight and ordered a new suppressor height S&W front sight. This combo has been used before with excellent results in sight alignment.