ReCreator Blanks

ReCreator Blanks All-American business striving to manufacture the finest high quality non-standard parts.

06/15/2026

M77 lower rivet hole needed an internal chamfer. We came up with a setup to make it happen. The original 77 trunnions have a tiny chamfer that barely holds the rivet – the rivet just gets squished down to nothing. Ours is actually better. More material, more bite, more secure. In the next video, I’ll show you how to use our tool to install the lower rivet the right way.

Hashtags:

06/05/2026

After almost a year of thinking about it, the M77 is finally coming together. Receiver blank is ready. Front trunnion is marked. Parts kit from Centerfire Systems is sitting on the bench. Next week we start building – and we’re gonna design some tooling along the way to make it easier. Follow along if you’re building one too.

Receiver blanks are shipping now. Trunnions ship Monday/Tuesday. Lot of us are gonna be going through this at the same time. Feels good to finally be here.

06/05/2026

Had trouble spreading M77 receivers to install center supports. Old snap ring pliers weren’t cutting it. Found a pair of fiber optic connector pliers with the right geometry—but they were too long. So we chopped ‘em. Now they’re perfect. Lots of leverage, works great for both installing and removing center support rivets.

06/02/2026

Point Break vibes. AK builders are the surfers. The system is the bank. We’re just here for the rush, not the money.

– Matt, ReCreator MFG

06/02/2026

Figured out I could’ve just used the original stripper plate the whole time instead of waiting for the relieved one. Didn’t even think about it until after I was done. So yeah, our motto around here is basically “work harder, not smarter.” All the geniuses out there planning and planning and getting nothing done – we just keep moving chips. Sometimes working hard beats working smart.

– Matt, ReCreator MFG

Hashtags:

06/02/2026

Punching out M77 ejector rails while I wait on the relieved stripper plate. Staggering the method for now – not ideal, but keeps the line moving. Still haven’t gotten the right tooling yet, but we’re not stopping.

– Matt, ReCreator MFG

06/02/2026

Just sat down in the office to clear the air. We had a website meltdown – long story short, Ecwid pulled the plug after 13 years. So we built our own. Self-hosted. No middleman. No one can shut us down again.

Back up. Back running. And honestly? Pretty proud of how fast we pulled it together.

– Matt, ReCreator MFG

05/22/2026

M77 Trunnion update video. Won’t be long now. .308 FTW

05/18/2026

Biggest and easiest run of Krinkov Combo blocks was just finished this week. Becoming more and more satisfied our processes, gotta say it was a slow start to utilize the 5th axis table but now there is no going back.. ever.

Address

Fallsington, PA

Opening Hours

Monday 9am - 8pm
Tuesday 9am - 8pm
Wednesday 9am - 8pm
Thursday 9am - 8pm
Friday 9am - 8pm

Telephone

+12678261079

Website

Alerts

Be the first to know and let us send you an email when ReCreator Blanks posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to ReCreator Blanks:

Shortcuts

Share

Category