Appliance knowledge

21/02/2026

How To Defrost Fridge Manually

03/02/2026

A genius girl has to fly to build her house

29/01/2026

Sign that your fridge needs a qualified technician

25/01/2026

25/01/2026

A washing machine can leak from several places, so the best fix depends on where the water is coming from. Watch this video until the end to learn something.

24/01/2026

How to repair or fix a washing machine that is not draining 5-Minute Crafts Men Hair Tutorials & Lifestyle Appliance knowledge Faithys 4C Curls Wood Mood

23/01/2026

Doing a full service on a tumble dryer is a great way to improve drying performance, reduce noise, and prevent breakdowns or fire risks. Since you often work on appliances.

🔌 1. Safety First
• Unplug the dryer from power
• If it’s a condenser or heat pump dryer, empty water tank
• Move dryer to a space where you can work all around it

⸻

🧹 2. Clean All Airflow Parts (MOST IMPORTANT)

✅ Lint filter
• Wash with warm water and soap
• Let dry fully

✅ Condenser (if fitted)
• Remove and rinse with water
• Clean fins gently
• Let it dry before refitting

✅ Air ducts & fan housing
• Open front or back panel
• Vacuum all lint buildup
• Clean:
• Fan / blower wheel
• Heater air channels
• Internal vents

23/01/2026

Replacing a door lock (interlock) on a front-loader washing machine is a moderate DIY job and usually takes 20–40 minutes.
Safety first

Unplug the washing machine from the power before starting. This is very important.

⸻

🔧 Step-by-step instructions

1️⃣ Open the door and remove the rubber seal clamp
• Open the washer door.
• Around the rubber gasket (seal) is a wire or spring clamp.
• Use a flat screwdriver to carefully pry it off.
• Peel the rubber seal back only around the door area.

⸻

2️⃣ Remove the door lock screws
• On the front of the machine (near the door lock), you’ll see 2 or 3 screws.
• Unscrew them.

⸻

3️⃣ Pull the door lock inside
• Reach behind the front panel and pull the lock inward.
• Carefully pull it out enough to access the wires.

⸻

4️⃣ Disconnect the wires
• Take a photo of the wire connections (important!).
• Remove the connectors from the old lock.

⸻

5️⃣ Install the new lock
• Connect the wires to the new door lock exactly as before.
• Push the lock back into position.
• Screw it back in place.

⸻

6️⃣ Refit the rubber seal and clamp
• Put the rubber seal back into position.
• Reinstall the wire/spring clamp around the seal.

⸻

7️⃣ Test the machine
• Plug in the washer.
• Close the door and try starting a cycle.
• You should hear the click of the door locking.

09/08/2025

Replacement of a belt on Speed Queen Washer

17/05/2025

How To Fix A Defy Stove That Is Not Heating

17/05/2025

The function of a compressor is explained here