10/06/2026
This video is a complete hands-on recording of the DSE5110 controller undergoing a manual start test on the test bench. It covers initial parameter checks, manual start operation, voltage/frequency comparison, and a low oil pressure alarm shutdown demonstration.
📌 Test Sequence Index:
1 – Initial state: Line voltage 0V, Current 0A, Pressure sensor 0, Default temperature 35°C
2 – Manual start initiated, test bench running normally
3 – Controller phase voltage vs. test bench phase voltage comparison (error within 1–2 units, normal)
4 – 3-phase 230V confirmed, phase voltage and frequency verification
5 – Pressure sensor reading and adjustment
6 – Low oil pressure alarm triggered, controller stops operation
Key Verification Points:
All pre-start values are zero or default, confirming proper sensor calibration
After manual start, controller readings closely match test bench parameters
Frequency reading matches the test bench
Low oil pressure condition triggers alarm and shutdown—protection logic verified
📧 Have questions? Leave a comment below.
🔔 Don't forget to like and subscribe for more generator commissioning tutorials.
